|
|
| Design |
- Windmill blades
Constructed of durable steel, hot-dipped
galvanized for maximum protection against the elements. Securely
attached to the head assembly.
- Head Assembly
Hot-dip galvanized pivoting head with regreasable rod-end
crank bearing, crankshaft bearings, pivot thrust bearing,
and electroplated crankshaft with fitted cast alloy fan
hub.
- Mast
Hot-dip galvanized pole with connecting rod, alignment blocks,
and clamps. Secured with guy wires, tensioners, and
hot-dip galvanized ground screw anchors. 11'6" (3.5 m)
tall, can be extended to 20 feet (6 m).
- Non-Immersible Pump
Lifts water from up to 25 feet (7.5 m) below the
pump level to a height as much as 170 feet (52 m)
above the pump. Needs
to be primed before first use. As long as the water
source does not run dry, the pump maintains its prime. With
a special reticulation system, will not over-draw the
water source.
- Pump Construction
Designed for years of trouble-free operation. Heavy
cast bronze body resistant to freezing. Stainless
steel pump rod, inlet valve, and ball valve. Brass
valve bodies and outlet valve. Bronze gland sleeve,
low-friction gland piston with fitted O-ring seal and high-quality
bark-tanned leather cup washer. 1 3/8-inch (35-mm)
bore with 1 1/2-inch (38-mm) stroke.
|
|
|
|
